7SENSe Subsystem
177 U2000 Series Programming Guide
enabled or disabled.
• 1 is returned when the table is enabled
• 0 is returned when the table is disabled
Query Example
Error Messages
If you attempt to set this command to ON and no table has been selected using
SENSe[1]:CORRection:CSET[2]:[SELect] then error –221, “Settings
conflict” occurs and SENSe[1]:CORRection:CSET[2]:STATe remains OFF.
SENS1:CORR:CSET2:STAT? This command queries whether there is
currently an active sensor frequency
dependent offset table for the sensor.
To Next Page
Loading...
