12 UNIT Subsystem
292 U2000 Series Programming Guide
UNIT Subsystem
The UNIT command subsystem:
• Sets power measurement units to dBm or Watts.
This UNIT command has a numeric suffix which determines which
window/measurement is set:
Figure 12-1 Measurement Display UNIT Block Window
The following commands are described in this section:
The UNIT:POWer command is as follows:
•If UNIT:POWer is set to dBm.
•If UNIT:POWer is set to W.
Keyword Parameter Form Notes Page
UNIT[1]
:POWer <amplitude unit> page 293
To Next Page
Loading...
