Agilent Technologies U2000 Series

11 TRIGger Subsystem
274 U2000 Series Programming Guide
TRIGger Commands
TRIGger commands control the behavior of the trigger system.
The following commands are described in this section:
TRIGger[1]:DELay:AUTO <boolean>
TRIGger[1]:SOURce BUS|EXTernal|IMMediate|HOLD
TRIGger[1][:IMMediate]
TRIGger:[SEQuence]:SLOPe <character_data>
TRIGger:SEQuence[1]:COUNt <numeric_value>
TRIGger:SEQuence[1]:DELay:AUTO <boolean>
TRIGger:SEQuence[1]:IMMediate
TRIGger:SEQuence[1]:SOURce
BUS|EXTernal|IMMediate|HOLD