7SENSe Subsystem
162 U2000 Series Programming Guide
SENSe[1]:AVERage Commands
These commands control the measurement averaging which is used to improve
measurement accuracy. They combine successive measurements to produce a
new composite result.
The following commands are detailed in this section:
SENSe[1]:AVERage:COUNt <numeric_value>
SENSe[1]:AVERage:COUNt:AUTO <boolean>
SENSe[1]:AVERage:SDETect <boolean>
SENSe[1]:AVERage[:STATe] <boolean>
To Next Page
Loading...
