6MEMory Subsystem
152 U2000 Series Programming Guide
MEMory:TABLe:GAIN[:MAGNitude]
<numeric_value>{,<numeric_value>}
This command is used to enter offsets into the frequency dependent offset
table, currently selected using MEMory:TABLe:SELect. Any previous offset list
is cleared before the new offsets are stored.
A maximum of 80 parameters for frequency dependent offset tables can be
sent with this command.
Entries in the frequency lists correspond as shown in Table 6- 2 with entries in
the offset factor lists.
Tab le 6-2 Frequency and Offset Factor List
Frequency Offset
Frequency 1 Offset 1
""
Frequency 80 Offset 80
To Next Page
Loading...
