9 STATus Subsystem
244 U2000 Series Programming Guide
STATus:QUEStionable:POWer[:SUMMary]
The questionable power summary register set contain bits that indicate the
quality of the power data being acquired by the power sensor.
The following bits in these registers shall be used by the power sensor:
Bit 1 is set when any of the following errors occur:
• Error –231, “Data questionable;Input Overload”
This bit is cleared when no errors or events are detected by the power sensor
during a measurement covering the causes given for it to set.
Syntax
Bit Number Decimal
Weight
Definition
0 - Not used
12Power
2 4 Not used
3 8 Not used
4 16 Not used
5 32 Not used
6 64 Not used
7 128 Not used
8 256 Not used
To Next Page
Loading...
Need help?
General
