3CALCulate Subsystem
94 U2000 Series Programming Guide
CALCulate[1]:LIMit:FCOunt?
This query returns the total number of limit failures for the current
window/measurement.
If the appropriate STATe commands are set to ON, each time a measurement is
initiated on the current window/measurement and the result is outside the
limits, the counter is incremented by one.
If the measured value is equal to a limit, this is a limit pass.
The counter is reset to zero by any of the following commands:
• *RST
• CALCulate[1]:LIMit:CLEar:IMMediate
• CALCulate[1]:LIMit:CLEar:AUTO ON
When CALCulate[1]:LIMit:CLEar:AUTO is set to ON, the counter is set to
zero each time a measurement is:
•measured using MEASure?
•read using READ?
• initiated using:
• INITiate[:IMMediate] or,
• INITiate:CONTinuous ON
When CALCulate[1]:LIMit:CLEar:AUTO is set to ONCE, the counter is set to
zero the first time a measurement is:
•measured using MEASure?
•read using READ?
• initiated using:
• INITiate[:IMMediate] or,
• INITiate:CONTinuous ON
The maximum number of errors is 2
16
–1. If more than 2
16
–1 errors are
detected the counter returns to zero.
To Next Page
Loading...
