vi U2000 Series Programming Guide
In This Guide ...
1
Power Sensor Remote Operation
Chapter 1 describes the parameters
that configure the power sensor and helps you determine settings to
optimize performance.
2
MEASurement Commands
Chapter 2 explains how to use the MEASure
group of instructions to acquire data using a set of high level instructions.
3
CALCulate Subsystem
Chapter 3 explains how the CALCulate
subsystem is used to perform post acquisition data processing.
4
CALibration Subsystem
Chapter 4 explains how the CALibration
command subsystem is used to zero and calibrate the power sensor.
5
FORMat Subsystem
Chapter 5 explains how the FORMat subsystem is
used to set a data format for transferring numeric information.
6
MEMory Subsystem
Chapter 6 explains how the MEMory command
subsystem is used to create, edit and review sensor calibration tables.
7
SENSe Subsystem
Chapter 6 explains how the SENSe command
subsystem directly affects device specific settings that are used to make
measurements.
8
SERVice Subsystem
Chapter 6 explains how the SERVice command
subsystem is used to obtain and set information useful for servicing the
power sensor.
9
STATus Subsystem
Chapter 7 explains how the STATus command
subsystem enables you to examine the status of the power sensor by
monitoring the “Device Status Register”, “Operation Status Register” and
the “Questionable Status Register”.
10
SYSTem Subsystem
Chapter 8 explains how the SYSTem command
subsystem is used to return error numbers and messages from the power
sensor, preset the power sensor, and query the SCPI version.
11
TRIGger Subsystem
Chapter 9 explains how the TRIGger command
subsystem is used to synchronize device actions with events.
To Next Page
Loading...
Need help?
General
