Power Sensor Remote Operation 1
U2000 Series Programming Guide 3
Introduction
This chapter describes the parameters which configure the power sensor and
help you determine settings to optimize performance. It contains the following
sections:
• “Configuring the Remote Interface” on page 4.
• “Zeroing and Calibrating the U2000 Series USB Power Sensors” on page 5.
• “Making Measurement” on page 7.
• “Using Frequency Dependent Offset Tables” on page 17.
• “Setting the Range and Averaging” on page 24.
• “Setting Offsets” on page 27.
• “Setting Measurement Limits” on page 28.
• “Getting the Best Speed Performance” on page 31.
• “How Measurements are Calculated” on page 35.
• “Status Reporting” on page 36.
• “Saving and Recalling Power Sensor Configurations” on page 50.
• “Using Device Clear to Halt Measurements” on page 51.
• “An Introduction to the SCPI Language” on page 52.
• “SCPI Compliance Information” on page 62.
• “Summary of Commands” on page 63.
To Next Page
Loading...
