1 Power Sensor Remote Operation
2 U2000 Series Programming Guide
Setting Offsets 27
• Channel Offsets 27
Setting Measurement Limits 28
• Setting Limits 28
• Checking for Limit Failures 29
Getting the Best Speed Performance 31
• Measurement Rate 31
• Trigger Mode 31
• Output Format 33
• Units 33
• Command Used 33
• Fast Mode 34
How Measurements are Calculated 35
Status Reporting 36
• The General Status Register Model 36
• How to Use Register 39
• The Condition Polling Method 39
• Status Registers 39
• Device Status Register 47
• Using the Operation Complete Commands 49
Saving and Recalling Power Sensor Configurations 50
• How to Save and Recall a Configuration 50
Using Device Clear to Halt Measurements 51
An Introduction to the SCPI Language 52
• Mnemonic Forms 52
• Using a Colon (:) 52
• Using a Semicolon (;) 53
• Using a Comma (,) 53
• Using Whitespace 53
• Using “?” Commands 53
• Using “*” Commands 54
• Syntax Conventions 54
• Syntax Diagram Conventions 54
• SCPI Data Types 55
• Input Message Terminators 61
SCPI Compliance Information 62
Summary of Commands 63
This chapter describes the parameters that configure the power sensor and
helps you determine settings to optimize performance.
To Next Page
Loading...
Need help?
General
