7SENSe Subsystem
160 U2000 Series Programming Guide
[SENSe] Subsystem
The SENSe command subsystem directly affects device specific settings used
to make measurements. The SENSe subsystem is optional since this is the
primary function of the power sensor. The high level command CONFigure
uses the SENSe commands to prepare the power sensor for making
measurements. At a lower level SENSe enables you to change the following
parameters: RANGe, FREQuency, LOSS, GAIN2 (channel offset), DCYCle
(duty cycle) and AVERage, without completely re- configuring the power
sensor.
The SENSe command subsystem also allows you to select the measurement , a
sensor calibration table, and a frequency dependent offset table.
Keyword Parameter Form Notes Page
[SENSe[1]]
:AVERage
:COUNt <numeric_value> page 163
:AUTO <boolean> page 166
:SDETect <boolean> [non-SCPI] page 169
[:STATe] <boolean> page 171
:CORRection
:CSET[2]
:SELEct <string> page 174
:STATe <boolean> page 176
:DCYCle|GAIN3 [non-SCPI]
[:INPut]
[:MAGNitude] <numeric_value> page 178
:STATe <boolean> page 181
:FDOFfset|GAIN4
:[INPut]
[:MAGNitude]? [query only] page 183
:GAIN2
:STATe <boolean> page 185
To Next Page
Loading...
Need help?
General
