3CALCulate Subsystem
86 U2000 Series Programming Guide
CALCulate[1]:FEED[1]<string>
This command sets the input measurement mode to be fed to the specified
input on the CALC block. It is applied to the measurement after the
CALC:MATH:EXPR command has been used to specify which measurement the
feed is taken from.
Under certain circumstances the measurement mode is changed by the
CALC:MATH:EXPR command. Refer to “CALCulate[1]:MATH[:EXPRession]
<string>” on page 104 for further information.
Syntax
To Next Page
Loading...
