Agilent Technologies U2000 Series

SERVice Subsystem 8
U2000 Series Programming Guide 208
SERVice:SENSor[1]:CDUEdate <“date”>
This command is used to enter the calibration due date.
Syntax
Example
Query
SERVice:SENSor[1]:CDUEdate?
This query returns the calibration due date in U2000 Series USB power
sensors. Calibration due date information is stored in the sensor’s non-
volatile memory.
Query Example
SERV:SENS1:CDUEdate
“2006,09,21”
This command enters the calibration due
date of the U2000 Series USB Power
Sensor as 21st September 2006.
SERV
1
:CDUE
:SENS
“date”
?
Space
SERV:SENS1:CDUEdate? This query returns the calibration due
date of the U2000 Series USB Power
Sensor.