Agilent Technologies U2000 Series - Initiate:continuous:all <Boolean

11 TRIGger Subsystem
268 U2000 Series Programming Guide
INITiate:CONTinuous:ALL <boolean>
Sets all trigger sequences to be continuously initiated.
If INITiate:CONTinuous:ALL is set to:
• ON, trigger sequences are set to be continuously initiated
• OFF, trigger sequences are not set to be continuously initiated
Syntax
Example
Reset Condition
On reset (*RST), this command is set to OFF.
On preset (SYSTem:PRESet) and instrument power- up,
INITiate:CONTinuous is set to ON.
Query
INITiate:CONTinuous:ALL?
INIT:CONT:ALL ON This command sets all trigger sequences
to be continuously initiated.
INIT
:CONT
0|OFF
1|ON
Space
?
:ALL