MEMory Subsystem 6
U2000 Series Programming Guide 129
MEMory:CATalog[:ALL]?
This command lists stored frequency dependent offset tables and save/recall
registers.
The power sensor returns the data in the form of two numeric parameters and
as many strings as there are stored tables and save/recall registers:
<numeric_value>,<numeric_value>{,<string>}
• The first numeric parameter indicates the amount of memory, in bytes,
used for the storage of tables and registers.
• The second numeric parameter indicates the memory, in bytes, available
for the storage of tables and registers.
• Each string parameter returned indicates the name, type and size of a
stored table or save/recall register:
• <string>, <type>, <size>
• <string> indicates the name of the table or save/recall register.
• <type> indicates TABL for frequency dependent offset tables, or STAT
for a save/recall register.
• <size> indicates the size of the table or save/recall register in bytes.
A sample of a response may look like the following:
1178,26230,"DEFAULT,TABL,14","TABLE1,TABL,116",
"TABLE2,TABL,74",..........."State0,STAT,1619",
"State1,STAT,1619","State2,STAT,1619" ...........
There are also ten frequency dependent offset tables named CUSTOM_A through
CUSTOM_J which do not contain any data when the power sensor is shipped from the
factory.
To Next Page
Loading...
Need help?
General
