261
Agilent U2000 Series USB Power Sensors
Programming Guide
Agilent Technologies
11
TRIGger Subsystem
TRIGger Subsystem 262
ABORt[1] 263
INITiate Commands 264
INITiate[1]:CONTinuous <boolean> 265
INITiate[1][:IMMediate] 267
INITiate:CONTinuous:ALL <boolean> 268
INITiate[1]:CONTinuous:SEQuence[1] <boolean> 270
INITiate[1][:IMMediate]:ALL 272
INITiate[1][:IMMediate]:SEQuence[1] 273
TRIGger Commands 274
TRIGger[1]:DELay:AUTO <boolean> 275
TRIGger[1][:IMMediate] 277
TRIGger[1]:SOURce BUS|EXTernal|HOLD|IMMediate 278
TRIGger[:SEQuence]:SLOPe <character_data> 281
TRIGger[:SEQuence[1]]:COUNt <numeric_value> 283
TRIGger[:SEQuence[1]]:DELay:AUTO <boolean> 285
TRIGger[:SEQuence[1]]:IMMediate 287
TRIGger[:SEQuence[1]]:SOURce BUS|EXTernal|HOLD|IMMediate 288
This chapter explains how the TRIGger command subsystem is used to
synchronize device actions with events.
To Next Page
Loading...
