CALCulate Subsystem 3
U2000 Series Programming Guide 105
Example
Reset Condition
On reset, the current window measurements are set to ("(SENS1)").
Query
CALCulate[1]:MATH[:EXPRession]?
The query returns the current math measurement setting on the current
window/measurement.
Query Example
Error Messages
• For single measurement, if <string> is not set to “(SENS1)” while
[SENSe[1]]:MRATe is set to FAST, error –221, “Settings Conflict” occurs.
CALC1:MATH “(SENS1)” This command sets the current
window/measurement to make a single
measurement.
CALC1:MATH? This command queries the current setting
of the math expression on the current
window/measurement.
To Next Page
Loading...
