6MEMory Subsystem
150 U2000 Series Programming Guide
Example
Query
MEMory:TABLe:FREQuency?
The query returns a list of frequency points for the table currently selected.
The frequencies are returned in Hz.
Query Example
Error Messages
• If more than 80 frequencies are in the list, error –108, “Parameter not
allowed” occurs.
• If the frequencies are not entered in ascending order, error –220,
“Parameter error;Frequency list must be in ascending order” occurs.
• If a table has not been specified using the MEMory:TABLe:SELect
command, the data cannot be entered into the table and error –221,
“Settings conflict” occurs.
• If a frequency is set which is outside of the allowed frequency range, error
–222, “Data out of range” occurs.
MEM:TABL:FREQ
200kHz,600kHz
This command enters frequencies of 200
kHz and 600 kHz into the currently
selected table.
MEM:TABL:FREQ? This command queries the frequency
points in the currently selected table.
To Next Page
Loading...
Need help?
General
