Agilent Technologies U2000 Series - Page 188

7SENSe Subsystem
170 U2000 Series Programming Guide
Syntax
Example
Reset Condition
On reset, step detection is enabled.
Query
SENSe[1]:AVERage:SDETect?
The query enters a 1 or 0 into the output buffer indicating the status of step
detection.
• 1 is returned when step detection is enabled
• 0 is returned when step detection is disabled
Query Example
SENS:AVER:SDET OFF This command disables step detection.
SENS
1
AVER
:
:SDET
0|OFF
1|ON
Space
?
SENS:AVER:SDET? This command queries whether step
detection is on or off.