7SENSe Subsystem
182 U2000 Series Programming Guide
• 1 is returned when the pulse power measurement feature is enabled.
• 0 is returned when the pulse power measurement feature is disabled.
Query Example
Error Messages
•If [SENSe[1]]:CORRection:DCYCle:STATus is set to ON while
[SENSe[1]]:SPEed is set to 200, the error –221, “Settings Conflict”
occurs.
CORR:GAIN3:STAT? This command queries whether the pulse
measurement feature is on or off.
To Next Page
Loading...
