7SENSe Subsystem
189 U2000 Series Programming Guide
Query Example
Error Messages
• If a loss/gain correction value is entered using
[SENSe[1]]|SENSe2:CORRection:GAIN2[:INPut][:MAGNitude] while
[SENSe[1]]|SENSe2: is set to 200, the error –221, “Settings Conflict”
occurs. However, the correction value is set but the
[SENSe[1]]|SENSe2:CORRection:GAIN2:STATe command is not
automatically set ON.
CORR:GAIN2? This command queries the current setting
of the channel offset.
To Next Page
Loading...
