SENSe Subsystem 7
U2000 Series Programming Guide 201
Reset Condition
On reset, autoranging is enabled.
Query
SENSe[1]:POWer:AC:RANGe:AUTO?
The query enters a 1 or 0 into the output buffer indicating the status of
autoranging.
• 1 is returned when autoranging is enabled
• 0 is returned when autoranging is disabled
Query Example
Error Messages
• If this command is set to ON when U2000 Series USB Power Sensor is in
Triggered modes, the error - 221, “Setting conflicts” occurs.
POW:AC:RANG:AUTO? This command queries whether auto
ranging is on or off.
To Next Page
Loading...
