STATus Subsystem 9
U2000 Series Programming Guide 225
STATus:DEVice (page 231)
STATus:OPERation (page 233)
STATus:OPERation:CALibrating[:SUMMary] (page 234)
STATus:OPERation:LLFail[:SUMMary] (page 235)
STATus:OPERation:MEASuring[:SUMMary] (page 236)
STATus:OPERation:SENSe[:SUMMary] (page 237)
STATus:OPERation:TRIGger[:SUMMary] (page 238)
STATus:OPERation:ULFail[:SUMMary] (page 239)
STATus:QUEStionable (page 240)
STATus:QUEStionable:CALibration[:SUMMary] (page 243)
STATus:QUEStionable:POWer[:SUMMary] (page 244)
Examples
•To use the :CONDition? command to examine the STATus:DEVice
register:
STATus:DEVice:CONDition?
• To use the :NTRansition command to examine the
STATus:OPERation:SENSe[:SUMMary] register:
STATus:OPERation:SENSe[:SUMMary]:NTRansition
This chapter describes the status register set commands and the status
registers which they are used to examine.
To Next Page
Loading...
Need help?
General
