11 TRIGger Subsystem
266 U2000 Series Programming Guide
Example
Reset Condition
On reset (*RST), this command is set to OFF.
On preset (SYSTem:PRESet) and instrument power- up,
INITiate:CONTinuous is set to ON.
Query
INITiate[1]:CONTinuous?
The query enters a 1 or 0 into the output buffer.
• 1 is returned when there is continuous triggering
• 0 is returned when there is only a single trigger
Query Example
INIT1:CONT ON This command places the sensor in the
wait for trigger state.
INIT:CONT? This command queries whether the sensor
is set for single or continuous triggering.
To Next Page
Loading...
