11 TRIGger Subsystem
284 U2000 Series Programming Guide
Example
Reset Condition
On reset, the value is set to 1.
Query
TRIGger:SEQuence[1]:COUNt?
The query returns the current setting of trigger events for the sensor.
Query Example
Error Messages
If COUNt >1 when [SENSe[1]]:MRATe <character_data> is set to NORMal or
DOUBle, error –221, “Settings Conflict” occurs.
TRIG:SEQ1:COUN 10 This command sets the number of
triggered events to 10 for the sensor
measurement cycle.
TRIG:SEQ1:COUN? This command queries the number of
triggered events for the sensor
measurement cycle.
To Next Page
Loading...
