11 TRIGger Subsystem
290 U2000 Series Programming Guide
Reset Condition
On reset, the trigger source is set to IMMediate.
Query
TRIGger:SEQuence[1]:SOURce?
The query returns the current trigger source.
Query Example
Error Messages
• If the source is changed to EXT and [SENSe[1]]:MRATe has a value of
FAST, error –221 “Settings Conflict” occurs.
• If the source is changed to EXT and [SENSe[1]]:DET:FUNC is set to
AVERage, error –221 “Settings Conflict” occurs.
TRIG:SEQ1:SOUR? This command queries the current trigger
source for the sensor.
To Next Page
Loading...
