Agilent Technologies U2000 Series

2 MEASurement Commands
68 U2000 Series Programming Guide
measurement.
• Whether the calculation is A- B or B- A, for a two difference measurement.
• Whether the calculation is A/B or B/A, for a ratio measurement.
The following commands are described in this chapter:
Keyword Parameter Form Notes Page
CONFigure[1] [query only] page 69
CONFigure[1]
[:SCALar]
[:POWer:AC] [<expected_value>
[,<resolution>[,<source list>]]]
[no query] page 72
FETCh[1]
[:SCALar]
[:POWer:AC]? [<expected_value>
[,<resolution>[,<source list>]]]
[query only] page 75
READ[1]
[:SCALar]
[:POWer:AC]? [<expected_value>
[,<resolution>[,<source list>]]]
[query only] page 78
MEASure[1]
[:SCALar]
[:POWer:AC]? [<expected_value>
[,<resolution>[,<source list>]]]
[query only] page 81