QUICKDESIGNER ASCII Flex Protocol •
••
• 283
Error #: 02:AE
Error Msg ERROR 02:AE Could not transmit because all of the echoes were not received
Explanation: The driver when in echo mode is suppose to echo all the characters it receives. If the
driver wants to transmit a string and it did not receives all the characters echoed from an earlier sent
command it will wait the time-out period for the echo of all the characters. If the driver does not
receive the echo of all the characters within the time-out period this error occurs. To fix the problem
increase the time-out period. If this does not fix the problem, make sure the controller is echoing all
the characters sent to it.
To Next Page
Loading...
