Chapter 2. Hardware Setup
97
KE6910ATC Point-to-Point Installation
Setting up the KE6910ATC system in a point-to-point configuration is simply
a matter of plugging in the cables.
Note: In a point-to-point configuration, no administrator setup is required.
Make sure that all equipment is powered off. Refer to the installation diagrams
on the next two pages and do the following:
1. (Optional) Use the grounding wire to connect the extender’s grounding
terminal to a suitable grounded object.
2. On the transmitter side, plug the mouse, keyboard, DVI-D monitor, serial
devices, microphone, and speakers into the ports on the console section of
the KE6910T.
3. Connect the USB DVI-D KVM cable provided with this package into the
KVM ports and the audio ports on the front of the KE6910T.
4. Connect the other end of the USB DVI-D KVM cable into the keyboard,
video, mouse, speaker, and microphone ports on the computer.
5. For control of serial devices, connect the RS-232 port on the front of the
transmitter to a serial port on the computer.
6. Connect a Cat 5e/6 cable to the primary KE6910T’s LAN port.
7. On the receiver side, plug the mouse, keyboard, DVI-D monitor, serial
devices, microphone, and speakers into the ports on the console section of
the KE6910R.
8. Connect the other end of the Cat 5e/6 cable to the KE6910R's LAN port.
9. Connect the SFP modules into the secondary KE6910T and KE6910R's
SFP slots, then connect each end of Gigabit Ethernet (GbE) optical fiber
between the SFP modules.*
10. Plug the power adapters into AC sources with the power cords; then plug
the other ends into the KE6910T and KE6910R's power jacks respectively.
11. (Optional) For power redundancy, plug the second power adapters into AC
sources with the power cords; then plug the other ends into the KE6910T
and KE6910R’s power jacks.**
12. Power on the computer.
To Next Page
Loading...
