Chapter 2. Hardware Setup
103
KE6920ATC Point-to-Point Installation
Setting up the KE6920ATC system in a point-to-point configuration is simply
a matter of plugging in the cables.
Note: In a point-to-point configuration, no administrator setup is required.
Make sure that all equipment is powered off. Refer to the installation diagrams
on the next two pages and do the following:
1. (Optional) Connect a grounding wire between the extender’s grounding
terminal and a suitable grounded object.
2. On the transmitter side, plug the mouse, keyboard, DVI monitor, and serial
devices into the ports on the console section of the KE6920T.
3. Connect the DVI-D cable and the USB 2.0 Type-A to Type-B cable
provided with this package into the KVM ports on the front of the
KE6920T.
4. Connect the other end of the USB DVI-D KVM cable into the keyboard,
video, mouse, speaker, and microphone ports on the computer.
5. For control of serial devices, connect the RS-232 port on the front of the
transmitter to a serial port on the computer.
6. Connect a Cat 5e/6 cable to the secondary KE6920T’s LAN port.
7. Plug the mouse, keyboard, DVI monitor, and serial devices into the ports
on the console section of the KE6920R.
8. Connect the other end of the Cat 5e/6 cable to the KE6920R's LAN port.
9. Connect the SFP modules into the primary KE6920T and KE6920R's SFP
slots, then connect each end of Gigabit Ethernet (GbE) optical fiber
between the SFP modules
1
.
10. Plug the power adapters into AC sources with the power cords and plug
the other ends into the KE6920T and KE6920R’s power jacks respectively.
11. (Optional) For power redundancy, plug the second power adapters into AC
sources with the power cords and plug the other ends into the KE6920T
and KE6920R’s power jacks
2
.
12. Power on the computer.
To Next Page
Loading...
