KVM over IP Matrix System User Manual
234
Basic
IP Installer
The IP Installer is an external Windows-based utility for assigning IP addresses
to the transmitter. Click one of the radio buttons to select Enabled, Disabled,
or View Only for the IP Installer utility. See p. 420 for IP Installer details.
Note: 1. If you select View Only, you will be able to see the transmitter in the
IP Installer’s Device List, but you will not be able to change the IP
address.
2. For security, we strongly recommend that you set this to View Only
or Disabled after using it.
Ports
Specify the ports that the transmitter uses for various network services.
Program: This is the port number for connecting to the transmitter from
the Windows Client and Java Viewers, and from the Windows and Java
Client AP programs. The default is 9000.
HTTP: The port number for a browser login. The default is 80.
HTTPS: The port number for a secure browser login. The default is 443.
Note: 1. Valid entries for all of the Service Ports are from 1–65535.
2. The service ports cannot have the same value. You must set a
different value for each one.
3. If there is no firewall (on an intranet, for example), it does not matter
what these numbers are set to, since they have no effect.
If a firewall is being used, the Administrator can specify the port numbers that
the firewall will allow (and set the firewall accordingly). If a port other than the
default is set, users must specify the port number as part of the IP address when
they log in. If not, an invalid port number (or no port number) is specified, the
transmitter will not be found.
To Next Page
Loading...
