351
Chapter 14
CLI Commands
Serial Control Protocol Commands
The KE Series’s built-in bi-directional RS-232 serial interface and LAN port
connection allows system control via Receivers through a high-end controller
or PC. This control feature can also be accessed via TCP/IP through a computer
running Telnet. The port for Telnet commands should be set to 9130.
Configuring the Serial Port
The controller’s serial port should be configured the same as the Receiver’s
default configuration, as shown below:
The Receiver’s Function Switch should be set to RS-232 Config (see page 13).
Before executing RS-232 commands across a network you must install the
KVM over IP Matrix Manager on a computer and ensure that it is online. For
the Slim Version of KE Series (KE8900ST/8900SR/9900ST). Please make
sure the RS-232 Serial Port is not connected before executing commands.
On your computer, open a terminal (command line) session. Please press
"Enter"or "T/t" to start “CLI Session” or "Text Menu".
Baud Rate 9600
Data Bits 8
Parity None
Stop Bits 1
Flow Control None
To Next Page
Loading...
