KVM over IP Matrix System User Manual
160
OSD Hotkeys
The OSD hotkeys navigate the Receiver’s OSD screens. The hotkeys work
after logging in from the System Login screen (see page 183) but not the OSD
Configuration screen. Pressing a hotkey will immediately take you to the
corresponding OSD screen.
Users can also use the [Page Up] and [Page Down] keys to jump to the previous
and next configuration pages.
Non-OSD Hotkeys
The following are the hotkeys that can be used without entering the OSD
screen:
Reverting to Previous
Users can use the [Alt] + [K] hotkey to switch back to the transmitter channel
previously accessed.
Note: For KE6900 / KE8950 / KE9950, [Alt] + [K] is not supported, but the
same operation can be achieved by pressing [K] under Hotkey Mode.
Hotkey Mode
The Hotkey Mode allows users to quickly switch from one transmitter to
another. Either press [Num Lock] + [-] or [Ctrl] + [F12] to enter Hotkey Mode.
Once in Hotkey Mode, you can use the [Next Arrow] and [Previous Arrow]
keys to quickly switch between different transmitters. You can also press a
Hotkey OSD Screen Page
[F1] Connections Page 1 in List Mode 184
[F2] Connections Page 1 in Array Mode 187
[F3] Profile Page 1 189
[F5] Push Content Page 1 190
[F6] Pull Content Page 1 192
[F7] Receiver > Properties 164
[F8] User Preferences 182
[F9] OSD Login Screen
(logs user off)
183
To Next Page
Loading...
