KVM over IP Matrix System User Manual
196
KVM over IP Matrix Manager Install
The following are instructions to install the full version of the KVM over IP
Matrix Manager on a primary or secondary computer. For software
requirements, see CCKM Requirements, page 10.
1. Insert the USB license key into a USB port on your computer. If using a
virtual license, skip this step and see Upgrading License, page 200, after
the installation is complete.
Note: If you have more than 8 KE Series devices in your setup, a USB
license key is required to install the KVM over IP Matrix Manager.
2. Double-click the KEMatrixManagerSetup file to start the setup. When the
Introduction screen appears, click Next.
To Next Page
Loading...
