UPS User Manual
420
IP Installer
From a client computer running Windows, an IP address for a transmitter or
receiver can be assigned with the IP Installer utility. The utility can be obtained
from the Download area of our website or from the product page on the
Software & Driver tab. After downloading the utility to your client computer,
do the following:
1. Unzip the contents of IPInstaller.zip to a directory on your hard drive.
2. Go to the directory that you unzipped the IPInstaller program to and run
IPInstaller.exe. A dialog box similar to the one below appears:
3. Select the Transmitter or Receiver in the Device List.
Note: 1. If the list is empty, or your device doesn't appear, click
Enumerate to refresh the Device List.
2. If there is more than one device in the list, use the MAC address
to pick the one you want. The MAC address is located on the
devices bottom panel.
4. Select either Obtain an IP address automatically (DHCP), or Specify an
IP address. If you chose the latter, fill the IP Address, Subnet Mask, and
Gateway fields with the information appropriate to your network.
5. Click Set IP.
6. After the IP address shows up in the Device List, click Exit.
To Next Page
Loading...
