KVM over IP Matrix System User Manual
374
Set Command
The Set command allows you to configure the properties of a device. Some
settings require that both the device and KVM over IP Matrix Manager are
online or the command will fail.
The formula for the Set command is as follows:
Command + Output + Input + Number + Control + Value + [Enter]
1. For example, to set the name of the local Receiver to KE6940TX1, type
the following:
set Name=KE6940TX1 [Enter]
2. For example, to set the description of Transmitter (192.168.0.33) to KE
Room B, type the following:
set o192.168.0.19 Description=KE Room B [Enter]
3. For example, to set the DHCP settings of Transmitter (192.168.0.28) to
static, type the following:
set i192.168.0.28 dhcpFlag=STATIC [Enter]
4. For example, to set the IP settings of the local Receiver to 192.168.0.2,
type the following:
set ipAddr=192.168.0.2 [Enter]
5. For example, to set the Transmitter Video IP setting to 192.168.0.44 for
Receiver (192.168.0.56), type the following:
set o192.168.0.56 TxVideoIP=192.168.0.44 [Enter]
The following tables show the possible values for the Set command
:
Command Description
set Set command
Output Description
o Output command
Input Description
i Input command
Number Description
xx Output or Input number
xx: Device ID or IP address
To Next Page
Loading...
