Chapter 12. Remote Viewer (AiT Models only)
325
Starting Up
For the first time running the AP, right-click the Windows/Java Client AP and
click “Run as administrator” to start.
The Client Connection Screen is shown below and each components are
described in the table. Windows Client will be the example shown here.
1. Double-click the unit. When the unit
is
connected, a login window appears:
Item Description
Server List When you run the Client program, it automatically searches
the user’s local LAN segment for AiT units, and lists
whichever ones it finds in this box. If you want to connect to
one of these units, double-click to connect.
Server If the AiT unit you wish to connect to is at a remote location, it
will not be found on your LAN. You can enter its IP address
and port yourself.
If you don’t know the Port number, contact the Administrator.
When the IP address and Port number for the unit you wish to
connect to have been specified, click Connect to start the
connection.
Connect Starts connecting to the AiT unit.
Disconnect These buttons become active once you log into the AiT unit.
Switch to remote view
Message panel The blank field on the right of the Server section shows the
current status of the server connection.
To Next Page
Loading...
