Chapter 6. System Status
251
Copy & Paste
Copy & Paste allows you to copy settings from one Receiver and paste them
to another. To copy Receiver settings to another device, do the following:
1. Select a Physical Receiver.
2. On the Receiver menu bar, click Copy & Paste (page 247).
3. Check the boxes of the settings you want to copy, and click Next.
Replace Device Click Replace Device in the top left corner to replace an old
Receiver with a new one.* All settings are copied from the old
Receiver to the new Receiver. Before using this feature, connect
the new Receiver to the network. After clicking Replace Device,
use the drop-down menu to select the new Receiver where the
settings will be applied.
Note:
1. This option only appears when a Transmitter is offline.
2. This feature can be used for both Receivers and
Transmitters. Replacement should be carried out on a
similar model.
Save Click Save to save changes to the properties.
Cancel Click Cancel to exit without saving.
Item Description
To Next Page
Loading...
Need help?
General
