KVM over IP Matrix System User Manual
218
RS-232
To log into the KE Series device by means of a RS-232 session, do the
following:
1. The controller’s serial port should be configured the same as the
Receiver’s default configuration, as shown below:
The Receiver’s Function Switch should be set to RS-232 Config (see page 45).
Before executing RS-232 commands across a network you must install the
KVM over IP Matrix Manager on a computer and ensure that it is online. For
the Slim Version of KE Series (KE8900ST/8900SR/9900ST). Please make
sure the RS-232 Serial Port is not connected before executing commands.
2. Please press “T / t” to start “TextMenu” The login screen appears. At the
login prompt, provide the Password.
Note: The default password for Telnet sessions is password.
Baud Rate 9600
Data Bits 8
Parity None
Stop Bits 1
Flow Control None
To Next Page
Loading...
