Chapter 2. Hardware Setup
155
KE ATC Series Bundle Hotkey
This bundle hotkey allows you to fast switch to any KE ATC Series transmitter
units in your network environment using the keyboard connected to the
receiver unit. These hotkeys are pre-configured to correspond to the IP address
you have configured in the KE OSD Receiver Properties page, see Properties,
page 164.
To fast switch to a transmitter unit, simply press the hotkey listed
below.
Hotkey Rule Example (Tx IP)
Ctrl + F1 Correspond to the Tx IP address in the
KE OSD Receiver Properties page.
192.168.0.61
(Transmiiter’s default IP address)
Ctrl + F2 Correspond to the Tx IP address + 1 in
the KE OSD Receiver Properties page.
192.168.0.62
Ctrl + F3 Correspond to the Tx IP address + 2 in
the KE OSD Receiver Properties page.
192.168.0.63
Ctrl + F4 Correspond to the Tx IP address + 3 in
the KE OSD Receiver Properties page.
192.168.0.64
Ctrl + F5 Correspond to the Tx IP address + 4 in
the KE OSD Receiver Properties page.
192.168.0.65
Ctrl + F6 Correspond to the Tx IP address + 5 in
the KE OSD Receiver Properties page.
192.168.0.66
Ctrl + F7 Correspond to the Tx IP address + 6in
the KE OSD Receiver Properties page.
192.168.0.67
Ctrl + F8 Correspond to the Tx IP address + 7 in
the KE OSD Receiver Properties page.
192.168.0.68
Ctrl + F9 Correspond to the Tx IP address + 8 in
the KE OSD Receiver Properties page.
192.168.0.69
Ctrl + F10 Correspond to the Tx IP address + 9 in
the KE OSD Receiver Properties page.
192.168.0.70
To Next Page
Loading...
