KVM over IP Matrix System User Manual
180
To specify a fixed IP address, select the Manual radio button and fill in the
IP address.
Note: 1. If you choose DHCP, when the transmitter starts up it waits to get its
IP address from the DHCP server. If it has not obtained the address
after one minute, it automatically reverts to its factory default IP
address, 192.168.0.61.
2. If the transmitter is on a network that uses DHCP to assign network
addresses, and you need to ascertain its IP address, you can use the IP
installer. See IP Installer, page 420 for information.
The transmitter can either have its DNS server address assigned automatically,
or a fixed address can be specified.
For automatic DNS Server address assignment, select the Obtain DNS
server address automatically radio button.
To specify a fixed address, select the Set DNS server address manually
radio button and fill in the required information.
Note: Specifying at the alternate DNS Server address is optional.
IPv6 Settings
The transmitter can either have its IPv6 address assigned dynamically at boot-
up (DHCP), or it can be given a fixed IPv6 address.
For dynamic IP address assignment, select the DHCP radio button. (This
is the default setting.)
To specify a fixed IP address, select the Manual radio button and fill in the
IP address.
The transmitter can either have its DNS server address assigned automatically,
or a fixed address can be specified.
For automatic DNS Server address assignment, select the Obtain DNS
server address automatically radio button.
To specify a fixed address, select the Set DNS server address manually
radio button and fill in the required information.
Note: Specifying at the alternate DNS Server address is optional.
To Next Page
Loading...
