Chapter 7. System Settings
287
SMTP Settings
To have the KVM over IP Matrix Manager email reports from the SMTP
server to you, do the following:
1. Enable the Enable report from the following SMTP Server, select the
Log Level (Information, Warning, or Error), and key in the SMTP
Server IP address and SMTP Port.
Note: The SMTP server used can either be TLS-encrypted or
unencrypted. CCKM shall send TLS-encrypted or unencrypted
email reports depending on the type of the SMTP server
connected.
2. If your server requires authentication, check the Server requires
authentication checkbox, and key in the appropriate information for the
Account Name and Password fields.
3. Key in the email address of where the report is being sent from in the
From field.
Note: 1. Only one email address is allowed in the From field, and it
cannot exceed 64 Bytes.
2. 1 Byte = 1 English alphanumeric character.
4. Key in the email address (addresses) of where you want the SMTP
reports sent to in the To field.
Note: If you are sending the report to more than one email address,
separate the addresses with a semicolon. The total cannot exceed
256 Bytes.
5. Click Save.
1. Once set, an SMTP report will be sent to the recipients for every
100 logs accumulated or once every 30 minutes.
2. An immediate SMTP report will also be sent whenever an error
log occurs.
Syslog Settings
To record all the events that take place on the KVM over IP Matrix
Manager and write them to a Syslog server, do the following:
1. Check Enable.
To Next Page
Loading...
