10. Card Cage
1
Image 10-23
2
Image 10-24
4. R emov e the com plete P MP board as sembly form the Input & Communication unit. Use a 2.5mm Allen wrench to loosen the 10
screws (reference 3 image 10-25) at the side and at the bottom as illustrated.
3
3
3
Image 10-25
5. R emov e the Warp m odule from the PM P board assembly. Se e "Replacing the Warp module", page 159.
6. R emov e the Deinterlacing module from the PMP board assembly. See "Replacing the Deinterlacing module", page 160.
7. R eplace the PMP board. Use a T10 Torx driver to loosen/fasten the 8 screws (reference 8 image 10-26) and use a 5.5mm nut
driver to loos en/fasten the five spacers (reference 9 image 10-26) as illustrated.
R5905312 HDF W SERIES 24/01/2013 157
To Next Page
Loading...
