Barco HDF W series - Page 53

5. Troubleshooting
Situation Solution
Malfunction Lamp Info Module. T he
projector c an not read from the
installed La mp Info Module.
In case no other “board read er rors” appears, replace the Lamp Info Module. The Lamp
Info Mo dule is located inside the La mp House, behind the blue socket. See "Lamp info
module replacement", page 13 8.
Malfunction internal RS485
communication line. The FCB, MCB
and CLO also reports “read er rors”.
Disconnect the board s one by one from the internal RS4 85 line until this error disappears.
Replace the board which makes this error goe s away. See chapter "Projector block
diagram", page 15, to know which boards are us ing the internal RS485 comm unication
line. If the pro blem remains replace the PMP.
1
Image 5-11
2
Image 5-12
6
Image 5-13
3
Image 5-14
Code 6055: “Board id: lamp info module write error” (Error)
Situation Solution
Malfunction Lamp Info Module. T he
projector can not write to the installed
Lamp Info Module.
Replace the Lamp Info Mod ule. See XXXX. (LAMP HOU SE)
Code 6056: “Board id: light sensor module unknown format” (Warning)
Situation Solution
Old projector softwa re installed. Th e
ID parameters of the Light Sensor
Module ar e written in a format
which is not known by the projector
software.
Check if the v ersion o f the installed projector software is the latest available v ersion. T he
latest version can be downloaded from h
ttps://my.barco.com.
Light Sensor M odule has invalid
firmware.
Replace the Light Sensor Module. See XXX X
Corrupt pr ojector s oftware. Reinstall the latest projector software.
R5905312 HDF W SERIES 24/01/2013 49