Canon imageCLASS MF273dw - Configuring LPD, RAW, or WSD

Conguring LPD
, RAW, or WSD
94LS-090
Select whether to use any of the pr
otocols below on the machine when printing or scanning documents from a
computer.
You are recommended to disable any protocols you will not be using.
When using LPD or RAW, you can congure the time until reception of print data is canceled.
LPD
This protocol is not dependent on the hardware, operating system, or other platform. It is commonly used in
TCP/IP network environments.
RAW
This is Windows' proprietary print data type protocol. It is used as standard in a Windows environment.
WSD
This protocol enables automatic detection of network-connected printers and scanners in a Windows
environment.
This section describes how to congure the settings using Remote UI from a computer.
On the operation panel, select [Menu] in the [Home] screen, and then select [Preferences] to congure the settings.
[TCP/IP Settings](P. 394)
Administr
ator privileges are required. The machine must be restarted to apply the settings.
1
Log in to Remote UI in System Manager Mode.
Starting Remote UI(P. 350)
2
On the Portal page of Remote UI, click [Settings/Registration]. Portal Page of
Remote UI(P
. 352)
3
Click [Network Settings].
4
Congure LPD
, RAW, or WSD.
When Conguring LPD
1
Click [LPD Settings]
[Edit].
➠ The [Edit LPD Settings] scr
een is displayed.
2
Set whether to use LPD.
When not using LPD
, clear the [Use LPD Printing] checkbox, and proceed to step 5.
3
Enter the time in [RX Timeout].
Enter the time in minutes from the start of reception standby, after print data reception is canceled, to
the timeout.
When Conguring RA
W
1
Click [RAW Settings] [Edit].
➠ The [Edit RAW Settings] screen is displayed.
2
Set whether to use RAW.
Security
343