Canon imageCLASS MF273dw - Confirming the Destination before Sending

Conrming the Destination befor
e Sending
94LS-08F
Congur
e the settings to display a screen conrming the destination before a fax is sent. Conrm that there are no
mistakes in the specied destination and entered information to prevent sending by mistake.
Choosing When to Display the Conrmation Screen
● When specifying a destination with a coded dial number
When a destination is specied with a coded dial number, the registered destination and destination name
are displayed on the conrmation screen. When a group is registered to a coded dial number, the group
name and number of destinations are displayed.
● When sending a fax
When you press [Start] to send a fax, a screen conrming the destination is displayed. Set whether to
display this only when sending to multiple destinations (Sequential Broadcast) or whenever sending a fax.
● When entering a fax number using the numeric keys
When you enter a fax number using the numeric keys and press [Start], a screen appears prompting you
to enter the number again. When you enter a second and subsequent destinations, they are displayed
before the next destination is entered.
This section describes how to congure the settings using Remote UI from a computer.
On the operation panel, select [Menu] in the [Home] screen, and then select [Function Settings] to congure the
settings.
[Common Settings] (Touch Panel Model)(P. 432) / [Conrm Enter
ed Fax Number](P. 438)
Administrator privileges are required.
1
Log in to Remote UI in System Manager Mode.
Starting Remote UI(P. 350)
2
On the Portal page of Remote UI, click [Settings/Registration]. Portal Page of
Remote UI(P. 352)
3
Click [TX Settings].
➠ The [TX Settings] scr
een is displayed.
4
Congure the setting so that the scr
een conrming the destination is displayed.
To display the screen when specifying the destination using a coded dial number
1
Click [Common Settings]
[Edit].
➠ The [Edit Common Settings] scr
een is displayed.
2
In [Common Settings], select the [Conrm When Using One-
Touch/Coded Dial TX] checkbox.
3
Click [OK].
To display the screen when sending a fax
1
Click [Common Settings]
[Edit].
➠ The [Edit Common Settings] scr
een is displayed.
Security
327