Canon imageCLASS MF273dw - Initializing the Settings and Data

Initializing the Settings and Data
94LS-09L
Y
ou can initialize the settings and registered data to reset the machine to the factory settings. You can initialize
specied settings and data only or initialize all settings and data.
Initializing Specic Settings and Data
You can initialize the following items separately:
● Settings menu: Initializes the settings of [Menu] in the [Home] screen.
● Key and Certicate: Initializes the settings of the key and certicate as well as CA certicate, and clears
everything except the pre-installed key and certicate.
● Address Book: Clears the destinations registered in the Address Book.
Initializing Specic Settings and Data(P
. 372)
Initializing All Settings and Data
You can reset all settings to the factory settings, and clear all stored data including logs. Initialization is
performed to prevent access to condential information and unauthorized use such as when replacing or
disposing of the machine.
Initializing All Settings and Data(P. 373)
Initializing Specic Settings and Data
This section describes how to initialize settings and data using Remote UI from a computer.
On the operation panel, select [Menu] in the [Home] screen, and then perform initialization from [Preferences] or
[Management Settings]. [Initialize Network Settings](P. 391) / [Data Management](P. 457)
Administr
ator privileges are required. Depending on the item to be initialized, you may have to restart the machine.
1
Log in to Remote UI in System Manager Mode.
Starting Remote UI(P. 350)
2
On the Portal page of Remote UI, click [Settings/Registration]. Portal Page of
Remote UI(P
. 352)
3
Click [Data Management].
➠ The [Data Management] scr
een is displayed.
4
Select the item to initialize.
Initializing the Settings Menu
Click [Initialize Menu], and select the setting to be initialized fr
om [Menu to Initialize].
When Initializing a Key and Certicate
Click [Initialize Ke
y and Certicate].
When Initializing the Address Book
Click [Initialize Addr
ess Book].
If the [Enter PIN] screen appears, enter the Address Book PIN, and then click [OK].
5
Click [Initialize]
[OK].
Managing the Machine
372