Canon imageCLASS MF273dw - Configuring SNTP

Conguring SNTP
94LS-01Y
T
o obtain time information from the time server on the network, congure Simple Network Time Protocol (SNTP).
When SNTP is congured, the time server is checked at specied intervals to adjust the time and maintain the correct
time on the machine.
The machine supports both an NTP server (NTPv3) and SNTP server (SNTPv3 and v4).
Congure these settings using Remote UI from a computer. You cannot use the operation panel to congure the
settings.
Administrator privileges are required. The machine must be restarted to apply the settings.
Required Preparations
● The time is adjusted based on the UT
C (Coordinated Universal Time), so specify the time zone setting.
Setting the Date and Time(P. 348)
● Pr
epare the IP address of the NTP or SNTP server and keep it close by.
1
Log in to Remote UI in System Manager Mode. Starting Remote UI(P. 350)
2
On the Portal page of Remote UI, click [Settings/Registration]. Portal Page of
Remote UI(P
. 352)
3
Click [Network Settings]
[SNTP Settings] [Edit].
➠ The [Edit SNTP Settings] scr
een is displayed.
4
Select the [Use SNTP] checkbox.
5
In [NTP Server Name], enter the IP address of the NTP/SNTP server.
When using a DNS server, you can enter the host name or FQDN instead of the IP address.
Input e
xample:
ntp.example.com
6
In [Polling Interval], enter the interval at which to check the server and adjust the
time.
7
Click [OK].
8
Restart the machine.
Restarting the Machine(P. 106)
➠ The settings ar
e applied.
Setting Up
87