Canon imageCLASS MF273dw - Page 68

If an Error Message Appears during Operation and a Connection Cannot Be Established
● Pr
ess [Close], and repeat the procedure starting from Step 2.
5 Lines LCD Model
1
On the operation panel, select [Wireless LAN Set.] in the [Home] screen and press .
[Home] Screen(P. 113)
➠ The [Select Network] scr
een is displayed.
● If the login screen appears, enter the System Manager ID and PIN, and then press
. System Manager
ID and PIN(P
. 5)
● If the message [Enable the wireless LAN?] appears, select [Yes] and press
.
● If the message [Cannot nd the access point.] appears, pr
ess
.
2
Select [Other Connections] and press
.
3
Select [WPS Push Button Mode] and press .
➠ The machine starts sear
ching for an access point.
4
After the search for an access point starts, press the button on the wireless LAN
r
outer within two minutes.
Press the button within two minutes. (Depending on the wireless LAN router, you may have to press and hold
the button.)
* For details on ho
w to operate the button, see the manual of your wireless LAN router.
5
When [Connected.] appears on the operation panel, press
.
➠ When the machine is connected to the wir
eless LAN, [
] appears on the [Home] screen.
6
Wait a few minutes.
➠ By default, an IP addr
ess is set automatically.
To use a specific IP address, set this manually.
Setting IPv4 Addresses(P. 71)
Setting IPv6 Addresses(P. 75)
If an Error Message Appears during Operation and a Connection Cannot Be Established
● Pr
ess
, and repeat the procedure starting from Step 2.
Setting Up
59