Canon imageCLASS MF273dw - Page 94

To Congur
e the Community Name
Select the [Use Community Name 1] or [Use Community Name 2] checkbox, and congure the
community name and MIB Access Permission.
Enter the community name using single-byte alphanumeric characters.
To Congure a Dedicated Community
Dedicated Community is a preset community for Canon Device Management software.
To use Dedicated Community, select the [Use Dedicated Community] checkbox, and congure MIB Access
Permission.
* For details, see the manual of the software you are using.
To Disable SNMPv1
Clear the [Use SNMPv1] checkbo
x.
5
In [SNMPv3 Settings], congur
e SNMPv3.
To Enable SNMPv3
1
Select the [Use SNMPv3] checkbox.
2
In [User Settings 1], [User Settings 2], or [User Settings 3], select the [Enable User] checkbox.
3
Congure the user.
[User Name]
Enter the user name using single-b
yte alphanumeric characters.
[MIB Access Permission]
Set the read/write permission to MIB objects for each specied user.
To allow both read and write, select [Read/Write].
[Security Settings]
Select whether to enable or disable authentication and encryption.
[Authentication Algorithm]
When [Authentication On/Encryption On] or [Authentication On/Encryption Off] is selected in [Security
Settings], select the authentication algorithm according to the usage environment.
To set a password, select the [Set/Change Password] checkbox, and enter the same password in both
[Authentication Password] and [Conrm] using single-byte alphanumeric characters.
[Encryption Algorithm]
When [Authentication On/Encryption On] is selected in [Security Settings], select the encryption algorithm
according to the usage environment.
To set a password, select the [Set/Change Password] checkbox, and enter the same password in both
[Encryption Password] and [Conrm] using single-byte alphanumeric characters.
To Disable SNMPv3
Clear the [Use SNMPv3] checkbo
x.
Setting Up
85